Digiop BLK-IPS101 Průvodce nastavením stáhnout pdf (Strana 9)

5NVR and hDVR Systems Setup Guide

SECTION 2: GETTING STARTED: UNPACKING YOUR SYSTEM

WARNING

Be sure to following all CAUTIONS and WARNINGS found with the system. Failure to do so may result in injury or

damage to the equipment.

Notes:

• IP devices – systems are compatible with many IP devices such as DIGIOP®Black cameras and encoders, and many AXIS

Sony

, Arecont

, Canon

, IQEye

, ACTi

, 3S, and other manufacturer’s cameras and encoders.

• NTSC or PAL – systems are compatible with NTSC or PAL, respectively, analog cameras.

• Ground loops and power uctuations – To ensure high-quality image capture and to prevent issues, check the system

for ground loops and power uctuations across the whole system.

• Low-light adjustments – Adjust the lighting, focus, or iris of the camera properly to avoid unnecessary motion detection in

low-light conditions.

• PTZ – systems do not support PTZ data signals or power on the video coax cables. Run separate cables to accommodate

system needs.

• Audio – All units come with at least one channel of audio; some come with multiple channels.

• Voice recording – Plug the microphone for voice recording into the microphone input jack. When the audio signal is line

level, then connect to the line-in jack. Connect the speaker to replay the recorded audio. The output signal is line level and

requires an amplier to boost the output signal for a speaker.

• Sensor inputs – These are activated by dry contact devices (the contact of a relay that does not make or break a current;

usually some other relay or device starts or stops the current) and are not “balanced.” Inputs connect to either N/O (normally

open) or N/C (normally closed) sensor contacts. Each input is congured in the software, depending on the input type. To

conrm correct operation, close the sensor device for at least 0.5 seconds.

• Relays – When using the Relay outputs, ensure that the voltage/current capacity of the relays is not exceeded.

• Network Connections – The Network settings are used to congure your system for DIGIOP® Control, DIGIOP® Connect,

and DIGIOP ELEMENTS™ accounts.

• IP devices – When using IP devices, to ensure that adequate bandwidth is available for system operations and video

transmission, set up a separate or segregated network. See the IP device manufacturer’s recommendations for bandwidth

requirements.

• Printers – If you are using a printer, make sure to use a good quality, color printer and appropriate paper to achieve optimal

results.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 46 47

Žádné komentáře

Digiop BLK-IPS101 Průvodce nastavením Strana 9