Digiop AH Series Průvodce nastavením

1DIGIOP® SV4000 Storage Vault Hardware Installation and Setup Guidewww.digiop.comDIGIOP® SV4000 Chassis for DIGIOP® Video and Data Management Systems

10Optiplex 790 chassis –EI21 series systemsMove the network interface card (NIC) to the second slot from the left, then install the STR-CTRL in the fo

11Optiplex 7010 chassis –EI22 series systemsMove the network interface card (NIC) to the second slot from the left, then install the STR-CTRL in the f

12Optiplex 990 chassis – AH40 series systemsInstall the STR-CTRL controller card in the fourth slot from the left (right-most slot) when looking at th

13Optiplex 9010 chassis – AH41 series systemsInstall the STR-CTRL controller card in the fourth slot from the left (right-most slot) when looking at t

14ii. Place the STR-CTRL card into place (see above), then slide it into the card connecter on the riser. iii. Close the expansion card latch. — I

15 NOTEDepending on your system BIOS conguration, Windows may try to boot through the RocketRAID card; ignore this screen, and allow the server to in

16c. Paste the path to the location where the drivers exist into the Browse entry eld in the window shown below, then click Next. 6. After your com

179. Verify that the Device Manager window does not show an alert status on the RocketRAID icon. See below. E. Conguring the DIGIOP® server to use

185. In the Change Drive Letter or Path pop-up window, select Assign the following drive letter, select Z form the drop down list, then click OK. If

1911. Open the Disk Management window. In the window shown below, note that volumes 1, 2, 3 and 4 (drives E, F, G and H) of the SV4000 are shown. Ver

2About the SV4000 Storage Vault The SV4000 Storage Vault is a high performance, high availability data storage appliance that is rack mountable and i

20Before editingAfter editing14. Complete the following only if you are using a DIGIOP ELEMENTS™ V8.1 or earlier. a. Open the DIGIOP system in kiosk

21d. In the Drive Selection menu, select Custom Selection, then e. In the drive list, select only the drives you want to use for archival storage.

22

3ComponentsBay 1, 2, 3 Bay 4, 5, 6 Bay 7, 8, 9 Bay 10, 11, 12Handle bracketChassis front viewAlarm MUTE buttonTemperature LEDFan LEDPower LEDAlert LE

4Half-height faceplate installedFaceplate attachment screwFaceplate attachment screwSAS cable connectorSASCABLE1M cable and STR-CTRL cardA. Install t

5 — For square-hole racks, extend the outer channel so that the tangs at each end t into the square holes in the vertical rack posts. Secure the chan

62. Starting at bay 1 and increasing sequentially, remove a drive tray from the bay for each HDD you are installing. To remove the drive tray, push i

7c. Remove the two faceplate retaining screws, then separate the faceplate from the board. d. Attach the half-height faceplate to the board using

8 » WIth OptiPlex chassis, lift the cover release latch, then lift the cover up and o the chassis. Lift cover at this edge rstCover release latchX

9Optiplex XE chassis – EI40 series systemsOriginally, the EI40 series systems have no expansion cards. Install the STR-CTRL in the fourth slot from th